14. Case 08: The Pencil Holder of the Minions

14.1. Introduction

A pen holder is a columnar container for holding pens or other long stationery, and comes in a variety of shapes and materials. Traditional penholders are made of wood, stone, pottery, bamboo, and other materials.

../_images/tooca-laser-1-case-08-01.png

14.2. Materials used

TOOCA laser 1

3mm Plywood

14.3. Relevant parameters

|Model|TOOCA Laser 1| |:——-:|:——-:| |Material of consumables|Basswood board| |Thickness|2.8mm| |Power|100%| |Speed|240mm/min| |Times required to be engraved/cut|3|

Note: This case takes a 2.8mm basswood board as an example. If you need to use different thicknesses or use different materials, please modify the drawing by yourself and refer to the Recommended parameter modify the parameters of the software.

14.5. Effect Show

../_images/tooca-laser-1-case-08-01.png

../_images/tooca-laser-1-case-08-02.png

../_images/tooca-laser-1-case-08-03.png

14.6. material data

More detail about the material：laser cutting material，Laser engraving material

Welcome to join the Laser Engraving Cutter Creative Sharing Community to share your creativity.